Figure 2-16Attaching A Caster To The Server - HP 9000 rp7420 Installation Manual

Hp 9000 rp7420 server installation guide

Hide thumbs Also See for 9000 rp7420:

Table of Contents

Unpacking the Server

Wheel Kit Installation

Step 9. Locate and remove one of the four screws from the plastic pouch. Attach a front caster to the server.

Figure 2-16Attaching a Caster to the Server

Step 10. Attach the remaining casters to the server using the screws supplied in the plastic pouch.

Step 11. Remove the foam blocks from the left and right side of the server.

Step 12. Locate the plywood ramp.

Step 13. Facing the front of the server, attach the plywood ramp to the edge of the pallet.

There are two pre-drilled holes in the ramp. Use the two screws taped to the ramp to attach

NOTE

the ramp to the pallet.

Step 14. Carefully roll the server off the pallet and down the ramp.

Step 15. Locate the caster covers.

NOTE

The caster covers are designed to fit on either side of the server.

It may be necessary to loosen or remove the mounted side covers to install the

supplied caster covers.

Front Casters

Chapter 2

Table of Contents