How To Enable System Features - Dedicated Micros DV-IP Decoder Setup Manual

How to Enable System Features

There are a number of features supported on the DV-IP Decoder that can be
enabled or disabled depending on your system requirements.
When these features are enabled, the relevant configuration web pages will be
displayed; if these are disabled then these pages will be omitted.
1. To enable the features select the System -> Advanced Features
2. By default the none of the system feature are enabled, to enable tick the box next to the
feature
3. Remember to select Save Settings!
4. You will now need to select Reload Webpages for the relevant configuration pages for the
enabled features to be displayed
5. Reset the unit will initiate the functions and also re-load the additional web pages
Section
Home
Network
Dedicated Micros
Feature
Register
Firewall
Configuration
Description
Note: Configuration and registration of the DV-IP Decoder is carried
out at the factory, therefore this screen is for factory use only and it is
recommended that the page is not enabled unless advised by
Dedicated Micros Technical Support
The DV-IP Decoder supports an on board firewall to ensure no
unauthorised users can access the unit. This will enable the
configuration page to be included in the Network tab
Page 29