Configuring The Dv-Ip Decoder; Web Page Icons - Dedicated Micros DV-IP Decoder Setup Manual

Configuring the DV-IP Decoder

To assist you with the configuration of the DV-IP Decoder, this section is constructed in a tutorial
manner and will make use of typical scenarios describing how to ........ allocate an IP address,
etc. Select the sections that are relevant to the functionality required for your application and
follow the step by step instructions.
As with the Installation of the unit this section will be divided into:
Simple Configuration – required to get the unit up and running
Advanced Configuration – project specific requirements
Note: It is presumed that configuration steps detailed in the DV-IP Decoder Quick Start Guide have been
followed and therefore the cameras inputs have been enabled and the standard record rate has been set,
although these features are detailed within this section.

Web Page Icons

Each of the DV-IP Decoder configuration web pages has the following buttons:
Reset to Defaults – this will return the associated page to factory defaults.
Display Help – this will display the Help pages for the associated configuration
page. This is a good starting point if you are having problems or do not understand
the configuration parameters.
Save Settings – this will save a changes that has been made to the configuration
page - remember to save the changes selecting a new page before saving the
changes will result in all changes will be lost!
Reset – this will be displayed on the configuration pages for functionality that
requires the unit to be reset to initiate the function, always save the settings before
resetting the unit.
For each How to.... section the Tab name and Function name will be shown allowing you to
easily locate the correct configuration page.
Dedicated Micros Page 25