Toshiba Strata AirLink Installation Manual page 54

RWIU System Installation
Step 1: Check DIP Switches and Jumpers on PCB
1. Check DIP Switch S1.
Table 11 S1 Factory Default Positions
Position
On Station 1
Inactive
Off Station 1
Active
Important!
Switch 8 is used to recover the RWIU in the event of a software load failure. Turn Switch 8
G
to its off position to force a download of the stored factory default software.
If any Base Station is not used, put its corresponding S1 switch in the on (inactive)
G
position. If the switch is in the off position, the WWIS subassembly LED 1 and 2 remain lit
and the RWIU tries to initialize that Base Station every 40 seconds.
2. Check DIP Switch S2.
Table 12 S2 Factory Default Positions (RF Signals)
Position
On
Off
1. RWIU must be in the master setting to operate.
2. DECT = Digital European Cordless Telecommunications
3. PCS = Personal Communication Service
3. Check DIP Switch S3 settings to ensure that the correct number of handsets are enabled (see
Table
Table 13 S3 Factory Default Positions (Number of Handsets)
4. Verify that the Watch Dog Timer (WDT) is jumpered correctly as shown in
44
Table 11
1 2
Base Base
Station 2 Station 3
Inactive Inactive
Base Base
Station 2 Station 3
Active
Table 12
1
1
Slave DECT
Master DECT Enabled
13).
S3 DIP Switch Number
1
On
Off
On
Off
gives the factory settings - defaults are in bold.
S1 DIP Switch Number
3 4
Base Base
Station 3 Spare
Inactive
Base Base
Station 4 Spare
Active Active
gives factory settings - defaults are in bold:
S2 DIP Switch Number
2 3
2 3
Disabled PCS Disabled
PCS Enabled
Number of
Handsets
2
On
On 16
Off 24
Off 32
5 6 7
Spare Spare
Spare Spare
4 5
Four Ports Spare
Two Ports Spare
8
Figure
Strata AirLink Installation Guide
8
Disable
Download
Force
Download
24.
5/00