Mitsubishi Electric FR-A740-00023 Instruction Manual page 173

(2) Jog operation from PU
⋅ Set the PU (FR-DU07/FR-PU07/FR-PU04) to the
jog operation mode. Operation is performed only
while the start button is pressed.
1.
Confirmation of the RUN indication and
operation mode indication
The monitor mode should have been selected.
The inverter should be at a stop.
2.
Press
PU JOG operation mode.
3.
Press
While
motor rotates.
Rotates at 5Hz. (initial value of Pr. 15)
4.
Release
[When changing the frequency of PU JOG
operation]
5.
Press
setting mode.
6.
Turn
appears.
7.
Press
value. (5Hz)
8.
Turn
"
9.
Press
10.
Perform the operations in steps 1 to 4.
The motor rotates at 10Hz.
CAUTION
⋅ When Pr. 29 Acceleration/deceleration pattern selection= "1" (S-pattern acceleration/deceleration A), the acceleration/deceleration
time is the period of time required to reach Pr. 3 Base frequency.
⋅ The Pr. 15 setting should be equal to or higher than the Pr. 13 Starting frequency setting.
⋅ The JOG signal can be assigned to the input terminal using any of Pr. 178 to Pr. 189 (input terminal function selection). When terminal
assignment is changed, the other functions may be affected. Please make setting after confirming the function of each terminal.
⋅ During jog operation, the second acceleration/deceleration via the RT signal cannot be selected. (The other second functions
are valid. (Refer to page 226))
⋅ When Pr. 79 Operation mode selection = "4", push
to make a stop.
⋅ This function is invalid when Pr. 79 = "3" or "6".
⋅ Jog operation is invalid under position control.
♦ Parameters referred to ♦
⋅ Pr. 13 Starting frequency
⋅ Pr. 29 Acceleration/deceleration pattern selection
⋅ Pr. 20 Acceleration/deceleration reference frequency, Pr. 21 Acceleration/deceleration time increments
⋅ Pr. 79 Operation mode selection
⋅ Pr. 178 to Pr. 189 (input terminal function selection)
Operation
to choose the
(or ).
(or ) is pressed, the
(or ).
to choose the parameter
until Pr. 15 JOG frequency
to show the currently set
to set the value to
". (10Hz)
to set.
/
Refer to page 169
Refer to page 170
Refer to page 301
Refer to page 222
Frequency setting by external terminals
R/L
Three-phase AC
S/L
power supply
T/L
Indication
Hold down.
Release
Flicker Parameter setting complete!!
of the PU (FR-DU07/FR-PU04/FR-PU07) to make a start or push
Inverter
U
1
Motor
V
2
W
3
FR-DU07
Stop
The parameter
number read
previously
appears.
Refer to page 167
4
163