Parameter Copy And Parameter Verification; Parameter Copy - Mitsubishi Electric FR-A720-0.4K Instruction Manual

4.30 Parameter copy and parameter verification

PCPY Setting
0 Cancel
1 Copy the source parameters to the operation panel.
2 Write the parameters copied to the operation panel into the destination inverter.
3 Verify parameters in the inverter and operation panel. (Refer to page 47.)
REMARKS
· When the copy destination inverter is not the FR-A700 series or parameter copy write is performed after parameter copy read is
stopped, "model error (
· Refer to the parameter list on page 444 and later for availability of parameter copy.
· When the power is turned off or an operation panel is disconnected, etc. during parameter copy write, perform write again or
check the values by parameter verification.

4.30.1 Parameter copy

Parameter settings can be copied to multiple inverters.
Operation
1.
Connect the operation panel to the
copy source inverter.
• Connect it during a stop.
2.
Press to choose the parameter
setting mode.
3.
Turn until
appears.
4.
Press to to read the currently set value.
" "(initial value) appears.
5.
Turn to change it to the setting value
" ".
6.
Press to copy the source parameters
to the operation panel.
7.
Connect the operation panel to the
copy source inverter.
8.
After performing steps 2 to 5,
turn to change it to "
9.
Press to write the parameters copied to
the operation panel to the destination inverter.
10.
When copy is completed,
" " and "
11.
After writing the parameter values to the copy
destination inverter, always reset the inverter,
e.g. switch power off once, before starting operation.
)" is displayed.

(parameter copy)

About 30s later
".
" flicker.

Parameter copy and parameter verification

Description
Display
The parameter
number previously
read appears.
Flickers for about 30s
Flicker ··· Parameter copy complete!!
The frequency flickers
for about 30s
Flicker ··· Parameter copy complete!!
4
381