Table of Contents
Advertisement
OWNER'S
INFORMATION
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Using Remote Control Handset
Wall Holder
Your fi replace equipment includes a wall
holder to store the handset. If it hasn't be
installed, refer to the instructions further
on in this manual for the installation.
Replacing Batteries
WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the battery box
or the handset! This could cause a short circuit.
Low batteries signal: see page 15.
BEFORE changing the batteries, disconnect the
battery box from the receiver.
The appliance uses four 1.5 V AA alkaline batteries
for its battery box and one 9 V alkaline battery for its
handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the off-
season will extend the battery life.
To replace the batteries in the battery box:
The battery box is located in a sliding carrier to the right
hand side of the appliance behind the front panel.
Window
Receiver
The battery box is located on the bottom of the appli-
ance behind the front panel on the valve access side.
8
Owner's Information
Battery box in carrier
1. Remove the barrier screen, the trim's side doors
and plinth. See the Cleaning section in the
preceeding pages for help with the screen removal.
Remove side doors
2. Slide the battery carrier to access the battery box.
Slide-in the battery carrier
to access battery box
3. Pull out the battery box and disconnect it.
Do not pull the box out by the
wire!
4. Remove the
screw and
slide the
cover off.
5. Replace the batteries with 4 AA alkaline batteries
orienting them as indicated inside the holder.
6. Replace the cover and screw in place.
7. Reconnect the battery box.
8. Put the battery box back in
the carrier and push it back
in position.
9. Reinstall the plinth, side
doors and barrier screen.
Remove plinth
battery box
Slide the battery carrier
back into position
Advertisement
Table of Contents
