Plan Wall Finish - Valor 1600IN Installation & Owner's Manual

L1 series
Hide thumbs Also See for 1600IN:
Table of Contents

Advertisement

QUALIFIED
INSTALLER

Plan Wall Finish

Non-combustible cement board
The L1 Linear see-thru fi replace requires
a 1/2" (13 mm) thick non-combustible
cement board to be used as a wall surface
immediately surrounding the unit on each
side—see diagram below for minimum
coverage.
Extending the cement board well beyond
the minimum shown will help avoid cracking
due to differential expansion of materials.
Pre-drill cement board with oversized holes
and do not over-tighten screws to avoid
cracking due to heat expansion.
Standard gypsum wall board may be used
beyond the perimeter of the cement board.
Finishing around trims
Additional non-combustible material such
as tile, etc., may be applied over top of the
wall surface or you may choose to leave it
fi nished clean with no tile, etc. Be aware
that a trim is always required and that only
the 1555 and 1550 style trims will accept
tile, etc. tucked behind them (up to 5/8"
thick for the 1555 and up to 1 inch thick
for the 1550). Additional non-combustible
fi nishes, if desired, may be butted up to the
concrete trim 1570RCS. Finish should not
cover the trims.
1 /
( 2
4 "
3 5
m
m
P o
)
( i n
Wider trim (1550) can
adjust up to 1" forward of
surface of cement board
36
(1130 mm)
Minimum cement board dimensions
s s i
b l e
t h
s c r
e d
e w
e s
i g n
l o c
a t e
d
Narrow trim (1555) can
adjust up to 5/8" forward of
surface of cement board
Installation
Gypsum board
up to perimeter
of cement board
Min.
20-1/2"
(521 mm)
Min.
44-1/2"
14-3/4"
(375 mm)
Min.
9-1/4"
(235 mm)
Board flush with
bottom of heater;
add extra if
overlapping
framing.
Note: When installing the 1555 1" trim,
allow space for the barrier screen lower
tabs by notching the cement
board/wall finish at the bottom
of the opening (same dimensions
on both sides)
a r d
o f
f l u
h e
s h
o v
a t e
e r l
w i
r ; a
a p
t h
d d
p i n
b o
e x
g f
t r a
r a m
i n g
Min. 53"
(1346 mm)
40"
(1016 mm)
1/4"
(7 mm)
1" (25 mm)
Joints preferred
1-3/4" (45 mm)
at corners to
prevent cracking
1/2" (13mm) thick
non-combustible
cement board
Wider trim (1570)
mounts directly over
the cement board

Advertisement

Table of Contents
loading

This manual is also suitable for:

1600ip

Table of Contents