Convert From Side To Top Outlet (If Required); Fit The Appliance Into Framing - Valor 1600IN Installation & Owner's Manual

3. Remove the 4 screws
retaining the engine to its
pallet.
4. Taking great care not to
cut your hands on the
sheet metal edges, lift the
appliance out of its packing
base and place it in the
framing. Make sure that
the unit is at the right height with consideration to
the height of the hearth or combustible fl ooring.
5. Install the heat shield on the top of the appliance
case (3 screws). If using the top outlet, discard the
shield.
Install heat shield (3 screws)
Convert from Side to Top Outlet
(if required)
This unit is supplied with a horizontal side vent outlet
which can be fi eld-converted to a top outlet.
Please note that the side outlet requires the
installation of the heat shield on top of the heater
case as indicated.
1. Remove the side outlet collar (6 screws).
Remove top outlet (6 screws)
Installation
2. Swivel the collar and install as a top outlet (6 screws).
Swivel the outlet so
that it is oriented
towards the top and
reinstall to heater
(6 screws)

Fit the appliance into framing

1. Fold out 3 mounting tabs on one face and recess
the appliance in the framing as shown. Fold out the
3 remaining tabs on the other side.
2. Fasten the unit to framing using 3 screws or nails at
the mounting tabs on each side.
Note: The sheet metal front face of the appliance is
fl ush with the framing studs.
Valve
access
side
Appliance fl ush to framing
on both faces
QUALIFIED
INSTALLER
Remove heat
shield if already
installed
(3 screws)
fl ush
mounting
front
tabs (3)
face of
appliance
35