Handlebar Installation - Yamaha Libero Workshop Manual

STEERING HEAD AND HANDLEBAR
6-31
4. Install :
• Front Fork
Refer to "FRONT FORK" Section, Page no
6-27
• Front Fender
• Front Wheel
Refer to "FRONT WHEEL" Section, Page
no 6-8

HANDLEBAR INSTALLATION

1. Install :
• Holder Handelbar Lower ¿
• Handlebar ¿
• Upper Handlebar Holder À
Bolt (Handlebar Upper Holder):
7.5 ~ 12 Nm (2.3 m.kg, 17 ft.lb)
NOTE :
• Apply a light coat of lithium soap base grease
onto the Handlebar right end
• The Upper Handlebar Holders should be in-
stalled with the longer side ç to the forward,
then tighten the Front Bolt as shown
2. Install :
• Front Brake Lever Assembly ¿
• Handlebar Switch (left)
• Grip Assembly
• Throttle Cable
• Housing (Throttle Grip)
NOTE :
Align the projection ç on the Handlebar Switch
with the Hole è in the Handlebar.
WARNING
Check the throttle grip for smooth operation
3. Adjust :
• Throttle Cable free play
• Brake operation
Refer to "THROTTLE CABLE ADJUSTMENT
/ BRAKE LEVER ADJUSTMENT" section in
Chapter 3, Page no 3-9 and 3-18
R-177
CHAS