Scanning System; After Replacing The Scanning Lamp - Canon iR2200 Service Handbook

CHAPTER 3 STANDARDS AND ADJUSTMENTS
1.6 Adjusting the Leading Edge Non-Image Width
1) Adjust the non-image width in service mode so that it is as indicated:
COPIER>ADJUST>ADJ-XY>ADJ-X.

2 Scanning System

2.1 After Replacing the Scanning Lamp

Run CCD auto adjustment in Service
Mode. This updates the CCD adjustment
data. Print out a new service label.
1. CCD Auto Adjust
COPIER>FUNCTION>CCD>
CCD-ADJ
2. CCD Adjustment Data
All items under
COPIER>ADJUST>CCD.
3-6
Decreasing the ADJ-X setting
(A decrease by '10' will decrease the width by 1 mm.)
Image leading edge
Increasing the ADJ-X setting
(An increase by '10' will increase the width by 1 mm.)
F03-106-01