Canon iR2200 Service Handbook page 226

CHAPTER 5 SERVICE MODE
NETWORK
Use it to check the network-related items for connection.
PING
Use it to check the connection between machine and the network (TCP/IP
only).
Caution Use this mode when checking the connection to the network at time of in-
stallation or when the connection to the network is faulty.
Using the Mode
1) Turn off the main power switch.
2) Connect the network cable to the machine, and turn on the main power
switch.
3) Inform the user's system administrator that the machine has been in-
stalled, and ask him/her to set up the network.
4) Inform the system administrator that the network connection will be
checked, and obtain the remote host address (IP address of the PC on the
user's network) for sending a PING.
5) Make the following selections: COPIER>TEST>NETWORK>PING.
Then, enter the IP address obtained in step 4) using the keypad; and press
the OK key.
• If the connection to the network is correct, 'OK' will be indicated. (End
the work.)
• If 'NG' is indicated, check the connection for the network cable; if nor-
mal, go to step 6). If a fault is found, connect the cable correctly, and go to
step 5).
5-98
Adjust
Display I/O
NETWORK
<
PING
Result(OK/NG)
F05-701-02
COPIER>TEST>NETWORK
Function
Option
1/ 1
READY
< >
> <
0 . 0 . 0 .
IP address input
+/-
Counter
Test
>
0
OK