CHAPTER 7 UPGRADING
1.5 Formatting the HDD
If you have replaced the HDD, you must format it and then download the system soft-
ware, RUI, and language.
1.5.1 Making Connections
The discussions that follow assume the use of a parallel cable:
1) Using a parallel cable, connect the PC to the parallel connector on the left side of the
controller.
•
At this time, the PC must remain OFF.
•
Connect the 25-pin connector of the bi-Centronics cable to the PC and the 36-pin con-
nector to the machine.
2) Turn on the PC, and start up the Service Support Tool.
3) Connect the machine's power plug to the power outlet; while holding down '2' and '8' of
the keypad at the same time, turn on the main power switch.
1.5.2 Starting Formatting
1) Under 'Downloading/Uploading', select 'To Next'.
7-20
F07-105-01