Basic Transmission Procedure - Kyocera TASKalfa 1801 Operation Manual

Sending Faxes > Basic transmission procedure

Basic transmission procedure

The basic procedure for using the fax system is explained below.
1
2
3
4
Press the [FAX] key.
Ready to send.
2013/08/08 10:10
200x200
Resltion
The base screen for fax appears.
Place the originals.
Refer to the machine's Operation Guide for placing originals.
Select the transmission method.
There are two transmission methods: memory transmission and direct transmission.
Memory transmission: The original is scanned into memory before communication starts.
Memory transmission is selected by default.
Direct transmission: The destination is dialed and communication starts before the original is
scanned.
For details, refer to FAX Direct Transmission on page
Specifying destination.
FAX No. Entry:
0123456789
Enter the fax number of the receiving system using the numeric keys.
For the procedure for selecting a destination in the address book, refer to
Address Book on page
For the procedure for selecting the destination using the One Touch Key, refer to
Touch Key on page 3-12.
NOTE
Up to 64 digits can be entered as the fax number of the receiving system.
Pressing the [Address
dialing. For example, when dialing the receiving system on an external line, you can use this
method to insert a pause before resuming dialing after you dial a specific number.
Off
Duplex
Chain Detail
3-10.
Recall/Pause] key adds about three seconds of waiting time during
3-2
3-17.
Choosing from the
Choosing by One