Low Beam Headlight Adjustment (Non Intl) - Polaris A12MH46AX Service Manual

1. Turn the back of the headllamp harness in a counter-
clockwise direction to loosen.
2. Pull the harness assembly out from the headlight
assembly.
3. Remove the lamp and replace with a new headlamp.
NOTE: Do not touch the new lamp with bare fingers.
Hold the plastic part (1) of the lamp. Oil from your
skin leaves a residue, causing a hot spot that will
shorten the life of the lamp.
4. Install the harness assembly into the headlight
assembly. Turn the headlight harness clockwise to
secure the headlamp into place.
Lower Headlamp Housing Removal (if required)
5. Remove the upper and lower portion of the front
bumper as outlined in chapter 5.
9923412 - 2012 Sportsman 400/500 and EFI Tractor Service Manual
© Copyright 2011 Polaris Sales Inc.
6. Remove the screw that secures the lower headlamp.
Remove Screw
7. Remove retaining O-ring from inner headlamp mount.
8. Pull the headlamp out of the locking tab.

Low Beam Headlight Adjustment (Non Intl)

1. The low beam can be adjusted slightly upward or
downward.
Loosen Screw
2. Loosen the phillips screw located at the rear of the
headlamp.
3. Tilt the headlamp upward or downward.
4. Tighten the screw.
ELECTRICAL
10
10.33