Operation Non Adc - Polaris A12MH46AX Service Manual

FINAL DRIVE

Operation NON ADC

The AWD switch may be turned on or off while the vehicle
is moving, however, AWD will not enable until the engine
RPM drops below 3100. Once the AWD is enabled, it
remains enabled until the switch is turned off.
Engage the AWD switch before getting into conditions
where the front wheel drive may be needed. If the rear
wheels are spinning, release the throttle before switching
to AWD.
CAUTION
Switching to AWD while the rear wheels are
spinning may cause severe drive shaft and
gearcase damage. Always switch to AWD while the
rear wheels have traction or are at rest.
With the AWD switch off, the vehicle drives through the
rear wheels only (2 wheel drive). When the AWD is
enabled, the front drive acts as an on-demand AWD
system. This means, the front drive will engage once the
rear wheels have lost traction, and will remain engaged
until the torque requirement goes away (i.e. rear wheels
regain traction).
Roll Cage Output Hubs
Ring Gear
7.8
Armature Plate
Magnetic Coil
9923412 - 2012 Sportsman 400/500 and EFI Tractor Service Manual
© Copyright 2011 Polaris Sales Inc.
AWD Engagement: When the AWD switch is activated,
the AWD coil is powered by a 12 Vdc input which creates
a magnetic field. This magnetic field attracts an armature
plate that is keyed to the roll cage. When the ring gear and
roll cage are spinning (vehicle is moving), the energized
coil and armature plate will apply drag to the roll cage that
indexes the rollers inside the ring gear to an engagement
position. While in the engagement position, the front drive
will be in an "over-running" condition (not engaged), until
the rear wheels lose traction. Once the rear wheels begin
to lose traction, the front drive will engage by coupling the
output hubs to the ring gear via the rollers. The front drive
will remain engaged until the torque requirement goes
away (i.e. rear wheels regain traction).
Rollers
Ring Gear
CAUTION
If the rear wheels are spinning, release the throttle
before turning the AWD switch on. If AWD is
engaged while the wheels are spinning, severe
drive shaft and clutch damage could result.
AWD Disengagement: Once the rear wheels regain
traction, the front wheels will return to the "over-running"
condition.The vehicle is now back to rear wheel drive until
the next loss of rear wheel traction occurs.
Roller Cage