Coolant Temperature Fan Switch - H.o; Gear Position Indicator Switch; Test Diagram - Polaris A12MH46AX Service Manual

Coolant Temperature Fan Switch - H.O.

The coolant temperature fan switch can be tested using an
ohmmeter.
If the fan switch circuit is open or failed, the engine "HOT"
light displays but the fan will not operate. It is
recommended that the fan switch be removed for testing,
as testing on the engine can be difficult to obtain a true test
reading.
1. With the engine and temperature sensor at room
°
temperature (68 F = 20
connector.
2. Drain the coolant sufficient enough to allow fan switch
removal. Remove the fan switch from the cylinder
head (recommended).
3. Place the fan switch in a water bath. Do not allow the
sensor to touch the bottom of the water container.
Slowly heat the water to 190°F (88°C) minimum. Use
the Temperature / Resistance table to determine if the
sensor needs to be replaced.
Table 10-2: H.O. Fan Switch
F (C)
T
EMPERATURE
149F (65C) 4
 
C) 8
180 F (82
NOTE: If the coolant temperature sensor or circuit
components malfunction, 'HOT' will display on the
instrument cluster, but the fan will not operate.
NOTE: The fan may not function or operation may
be delayed if coolant level is low or if air is trapped in
the cooling system. Verify the cooling system is full
and purged of air. Refer to Maintenance Chapter 2
for cooling system information.
°
C), disconnect the harness
R
ESISTANCE
Open - (infinity)
Closed - 0.0
9923412 - 2012 Sportsman 400/500 and EFI Tractor Service Manual
© Copyright 2011 Polaris Sales Inc.

GEAR POSITION INDICATOR SWITCH

Test Diagram

Refer to "TEST 8 - Transmission Shift Indicator Not
Working" on page 10.15.
TRANSMISSION SWITCH
High/Low/Neutral/Reverse/Park
High
Range
Low
Range
Neutral
Green/White Brown/Red (Carb - Bn)
Violet (purple)
Orange/Red
ELECTRICAL
White/Blue
Blue/Red
10.19
10