High Beam Adjustment; Low Beam Adjustment - Polaris Sportsman 570 EFI Owner's Manual

Lights

High Beam Adjustment

The headlight beam can be adjusted slightly upward or downward. Use
the following procedure to make the adjustment.
1. Position the vehicle on a level surface with the headlight
2. Measure the distance from the floor to the center of the headlight
3. Start the engine. Turn the headlight switch to high beam.
4. Observe the headlight aim on the wall. The most intense part of the
5. The adjustment knob is located on the right side of the headlight

Low Beam Adjustment

The low beam can be adjusted slightly
upward or downward.
1. Loosen the Phillips screw located
2. Tilt the headlamp upward or
3. Tighten the screw.
Downloaded from www.Manualslib.com
x
approximately 25 ft. (7.6 m) from a wall. Place the transmission in
PARK.
and make a mark on the wall at the same height.
headlight beam should be two inches (5 cm) below the mark on the
wall. Include rider weight on the seat when measuring.
pod. Adjust the beam to the desired position by turning the knob
either clockwise or counter-clockwise.
at the rear of the headlamp.
downward.
manuals search engine
MAINTENANCE
25 ft.
(7.6 m)
x
2" (5 cm)
Phillips
Screw
101