Table of Contents
Advertisement
(c) GT105
The standard interface includes the following three types.
Standard I/F-1(RS-422): For communication with PLC, microcomputer and other equipment
Standard I/F-2(RS-232): For communication with PLC, PC (drawing software), modem,
Standard I/F-3(USB):
Standard I/F-1 (RS-422)
Standard I/F-2 (RS-232)
(3) Channel No. specification menu BOX
0:
Set when the communication interface is not used.
1:
Set when connecting to PLC or microcomputer.
(For GT1020 and GT1030, settable only for the interface (Standard I/F-1) for communication
with PLC)
(For GT104 , GT105 , either of standard I/F-1 or standard I/F2 can be set.)
8:
Set when connecting to bar code reader.
9:
Set when connecting to PC (drawing software), modem. (For standard I/F-2 and standard I/F-
3, the simultaneous setting is possible. However, when either interface is communicating, the
communication is not allowed for another interface.)
• Setting is not allowed for 2 to 7, *.
• Fixed to 9 for the USB interface.
(4) Driver display BOX
The name of the communication driver for which a channel number is assigned is displayed.
"None" is displayed in the driver display box in the following cases :
• The communication driver is not installed. (
• "0" is set in the channel number specification menu box.
[*****] will appear when the communication driver that was installed on the GOT from drawing
software and the controller setting that was downloaded on to the GOT from drawing software do
not match.
When setting the channel number to "9", the communication driver "Host (PC)" is automatically
assigned.
When the driver display box is touched, the screen jumps to the detail information screen and the
communication parameter appears.
11 - 4
11.1 Standard I/F Setting
11.1.3 Display contents of standard I/F
other equipment, bar code reader and transparent
For communication with PC (drawing software) and transparent
[GOT back panel]
Standard I/F-3 (USB)
Section 14.2 OS Information)
Advertisement
Table of Contents
