Writing Commands - Mitsubishi GT10 User Manual

15.3.10 Writing commands

Writes a sequence program to the FX PLC. (Overwrite/Insert)
1 Writing basic commands
(1) Operations
(a) Inputting command only (Ex.: ANB, ORB command etc.)
Stop the FX PLC
(b) Inputting command and device (LD, AND commands etc.)
Stop the FX PLC
(c) Inputting command, No. 1 device, No. 2 device (MC, OUT (T, C) commands, etc.)
Stop the FX PLC
SP
(2) Example
(a) Writing ORB command
Stop the FX PLC
With
cursor to the position to
overwrite/insert the command.
MODE
For overwriting: (WRITE mode)
For insertion: (INSERT mode)
MODE
For overwriting: (WRITE mode)
For insertion: (INSERT mode)
Input the device name and device number
MODE
For overwriting: (WRITE mode)
For insertion: (INSERT mode)
Input the device name and device number
Moving the cursor to the position to write the command
When starting to write a command, place the cursor on the command line (the line
on which the step number is displayed).
You cannot write a command with the cursor on an operand or set value line.
2 LDI M
3 MOV
D
D
< READ >
MODE
Set the
WRITE or
< WRITE >
INSERT
mode
or , move the
Input the command
GO
Input the command
GO
Input the command Input the device name and device number
GO
100
Command line (Place the cursor on this line.)
12
0
Operand, set value line (Cannot operate on this line.)
10
4 LDI
5 AND
6 NOP
7 NOP
ORB
4 LDI
5 AND
6 ORB
7 NOP
15.3 FX List Editor (For GT104[ ], GT105[ ] only)
15.3.10 Writing commands
X 004
X 005
GO
X 004
X 005
15 - 27
9
10
11
12
13
14
15
16