Table of Contents
Advertisement
15. GOT DEBUG
15.1 Debug
The debug includes functions to check the PLC system status and to improve troubleshooting efficiency.
The following is available as the debug.
Items
For a controller connected to the GOT, forcibly turning on or off devices of the controller and
Device monitor
changing the set value or present value are available.
FX list editor
15.2 Device Monitor
For a controller connected to the GT10
the set value or present value are available.
15.2.1 System cofiguration
This section describes the controller names and connection types between the GOT and a controller that are
applicable to the device monitor function.
For details of communication units and cables for each connection type, refer to the following manual.
GOT1000 Series Connection Manual
1
Target controller
*1
Controller
QCPU (Q mode)
QnACPU
ACPU, QCPU (A mode) Direct CPU connection, Computer link connection
FXCPU
*1 : For details of controllers that can be monitored, refer to the following manual.
2
Required OS
The OS shown in the table below is required.
Standard monitor OS
Communication
driver
GT1020
-
, forcibly turning on or off devices of the controller and changing
Direct CPU connection, Computer link connection, CC-Link(G4) connection
Direct CPU connection, Computer link connection
Direct CPU connection
GT Designer2 Version
Screen Design Manual
GOT1000 Series Connection Manual (Mitsubishi Products)
OS
MELSEC-FX
QnA/Q
MELSEC-A
AJ71C24/UC24
CC-Link(G4)
Checking method of OS, Communication driver version
Check the version of OS or communication driver installed in GOT at [OS
information] of the utility.
Refer to the following for details.
Section 14.2 OS Information
Contents
GT1030
GT104
Sequence program and parameter change of FX
PLC.
Connection type
Version
01.09.** or later
01.04.** or later
15.2.1 System cofiguration
GT105
15.1 Debug
15 - 1
9
10
11
12
13
14
15
16
Advertisement
Table of Contents
