Table of Contents
Advertisement
8.4 Memory loader
GT10-LDR memory loader is the memory transfer module that reads/writes the data to GT1020, GT1030 or
between a PC (GT Designer2 Version2.77F or later, GT Designer3 Version1.01B or later) and GT10-LDR.
When using the memory loader, driver installation, communication port setting is required.
Refer to the following manual for details about driver installation.
GT1020, GT1030
*1:
8 - 12
8.4 Memory loader
8.3.3 Battery replacement procedure
GT Designer2 Version
GT Designer3 Version
When GT10-LDR is connected to a PC via the USB hub, the power supply of the USB hub must be supplied by
the AC adopter of the USB hub.
GT10-LDR connected to the USB hub may not work properly depending on the PC environment. In the case,
connect the GT10-LDR directly to the USB port on the PC.
Basic Operation/Data Transfer Manual
Screen Design Manual (Fundamentals)
*1
PC
(GT Designer2, GT Designer3)
USB connecting
cable (supplied)
Advertisement
Table of Contents
