Installing / Removing the Docking Bay Adapter Cup
Equipment: Phillips screwdriver and torquing tool (not supplied by Honeywell). You will need a torquing tool capable of
torquing up to 6 (+/- .5) in/lb. Use a clean, well-lit stable surface.
The desktop cradle is shipped with the docking bay adapter cup pre-installed. If the MX8 has a rubber boot, the docking bay
adapter cup must be removed before the MX8 is placed in the desktop cradle.
The desktop cradle can secure an MX8 with a rubber boot (MX8402BOOT or MX8403BOOT) enclosing/protecting the
mobile device.
Before docking an MX8 without a rubber boot in the cradle, re-install the docking bay adapter cup.
Installing
The adapter cup is installed facing in one direction. Put the adapter cup in the MX8 docking bay, aligning the screw
hole in the adapter cup with the screw hole in the MX8 docking bay.
Using a torquing screwdriver, insert the screw in the adapter cup screw hole, and torque the screw to 6 in/lbs +/- .5 in/
lbs.
Periodically check the connection of the adapter cup and re-torque if necessary.
Removing
Remove the adapter cup by unscrewing the single captive screw at the front of the adapter cup.
Place both the adapter cup and the screw in a protected, safe area until needed.
12 - 7