Docking And Undocking The Mx8; Safety Guidelines And Cautions - Honeywell MX8 User Manual

Docking and Undocking the MX8

See Installing / Removing the Docking Bay Adapter Cup
When the MX8 is in Suspend Mode it wakes up when it is docked in a powered Multi-dock charging bay. There is no change
in mode state settings or behavior when the MX8 is docked in a Multi-dock without a power source. MX8 mode states while
the MX8 is in a powered Multi-dock e.g., suspend, resume, display backlight, etc., are managed by the MX8 OS Power
settings.
If the Multi-dock is not permanently attached to the horizontal surface, stabilize the Multi-dock with one hand while inserting
or removing the MX8 with the other hand.
Remove the MX8 from holster, carry cases and voice cases before docking the MX8.
The MX8 is inserted into a Multi-dock charging pocket with the keypad facing forward.
Docking the MX8
Remove any cables attached to the base of the MX8.
Carefully press the MX8 straight down into the charging bay until the multi-pin connector at the base of the MX8 clicks into
place with the multi-pin charging connector at the bottom of the charging bay. The Multi-dock charging bays are designed to
secure the MX8 with the keypad facing forward.
The left LED illuminates.
Undock the MX8
Remove the MX8 from the charging bay by pulling it straight up and out of the charging bay. If necessary, brace the Multi-
dock with one hand while the other hand removes the MX8.
The left LED turns Off.

Safety Guidelines and Cautions

• It is recommended that a grounded three (3) prong AC outlet be used to power this device. The user should insure that
the AC outlet is grounded before using this device. If you are not sure that the AC outlet has appropriate ground, we
suggest that a qualified electrician be called for verification.
• Do not pour, spray or spill any liquid into or on the multi-dock. If liquid does come in contact with the multi-dock,
immediately un-plug the multi-dock and remove any mobile devices in the docking bays.
• For Indoor Use Only.
• Before using this multi-dock, read all instructions and cautionary notations on the multi-dock and on the MX8.
• To reduce risk of injury, only use authorized battery products in the MX8. Other non-approved batteries may cause
personal injury and / or damage to the equipment.
• Do not expose the multi-dock to excessive moisture, temperature extremes or direct sunlight.
• Place multi-dock in a well ventilated area, which is free of foreign materials.
• To reduce risk of electric shock, unplug multi-dock from power source before cleaning.
• Dispose of used batteries in accordance with your state or local hazardous material laws.
• Dispose of multi-dock correctly according to local regulations to comply with WEEE regulations.
• Do not disassemble, incinerate, modify, or short circuit the multi-dock, any battery, or related components.
12 - 14
(page 12-7).