Assembling The Carry Case; Carry Case With Metal Snaps; Assembling The Voice Case - Honeywell MX8 User Manual

Assembling the Carry Case

Note: Accessory installation or removal should be performed on a clean, well-lit surface. When necessary, protect the work
surface, the MX8, and components from electrostatic discharge.
1. Remove any cables connected to the I/O port at the bottom of the MX8.
2. Remove the rubber boot from the MX8.
3. Separate the hook and loop fabric on the carry case without removing the hook and loop fabric from the carry case.
4. Slip the removable, clear plastic protector for the keypad and touch screen into the case. Position it against the openings for
the keypad and touch screen in the case. The voice case does not require the clear plastic protector.
5. Slide the MX8 into the case, making sure the touch screen and keypad (including the Scan LED) are visible and accessible
through the front openings of the case.
6. Securely tether the stylus to the case, if necessary. Place the stylus in the stylus holder on the handstrap or in the trigger
handle.
7. Loosen then tighten the handstrap (on cases without a trigger handle opening) until the carry case assembly is secure in
your hand.
8. When a shoulder strap is available,secure the clips at each end of the shoulder strap to the D rings on either side of the carry
case. The shoulder strap allows the MX8 to hang upside down until needed.
The main battery can be removed and inserted without taking the MX8 out of the carry case.

Carry Case with Metal Snaps

The metal snap has a bulge in the lip and a dot indentation on the opposite side. To snap the cap closed, tuck the lip bulge
under the snap lip and press on the dot to snap closed.
Pull the snap up to open.

Assembling the Voice Case

The voice case is a sturdy, lightweight, protective covering for the MX8. The voice case cannot protect the MX8 from destructive,
excessive force or a harsh or wet environment. It is designed to protect the MX8 from dirt, dampness, and minor, trivial bumps
or jostling. The MX8 battery cannot be hotswapped while the MX8 is enclosed by the voice case.
Voice Case Front
1. Open the belt loop on the voice case. The belt loop snaps are self locking at the dimple. Locate the dimple on each belt loop
snap. Unfasten each belt loop snap by using your thumb to push the snap head upward at the dimple.
2. Place the belt on the voice case inside the open area of the belt loop. Fasten the belt to the voice case. Lock each belt loop
snap by rocking the snap head onto the snap base (starting on the opposite side of the dimple) and pressing down on the
dimple side of the snap head.
3. Do not put the belt on yet.
4. Attach the audio adapter/cable to the base of the MX8. Do not connect the headset to the cable yet.
5. Slip the MX8 into the voice case, with the keypad and touch screen facing the front of the case. The audio cable should be
exiting the side opening at the left side of the case. If it is not, remove the MX8 from the voice case, turn it around and insert
into the voice case again.
6. Close the voice case cover by folding the hook side over the loop side. Press along the length of the cover until the hook and
loop fabric is secure.
2 - 22
Belt Loop Snaps