Attaching the Handstrap
Either the trigger handle is attached to the MX8 or the handstrap is attached, not both. In the absence of a trigger handle, the
handstrap should be used at all times. The handstrap is pre-installed on a MX8 that is purchased without a trigger handle.
Tool Required: Phillips #1 screwdriver (not supplied)
1. Place the MX8 with the screen facing down, on a flat stable surface.
2. Attach the handstrap retainer bracket to the MX8 with the screws and washers provided.
3. Slip the Handstrap Clip into the bracket at the base of the MX8.
4. Making sure the closed loop fastener surfaces on the handstrap are facing up, slide the strap through the pin in the bottom
bracket and the clip.
5. Fold each end of the strap over so that the closed loop fastener surfaces mate evenly.
6. Test the strap's connection making sure the MX8 is securely connected to each end of the handstrap's connectors.
7. Check the closed loop fastener, retainer bracket and clip connections frequently. If they have loosened, they must be
tightened or replaced before the MX8 is placed into service again.
2 - 20
1. Handstrap Retainer Bracket
2. Handstrap and tethered stylus
3. Handstrap Clip