Kyocera TASKalfa 3501i Operation Manual page 456

Troubleshooting > Troubleshooting
Symptom
2 or more sheets are
overlaps when ejected.
(multi feed)
Printouts are wrinkled.
Printouts are curled.
Cannot print.
Cannot print with USB
memory.
USB memory not
recognized.
Printouts have vertical lines.
Checkpoints
―
Are the originals loaded correctly?
―
―
Is the paper damp?
―
Is the paper damp?
Is the paper printed out to the finisher?
―
Is the machine plugged in?
Is the machine powered on?
Are the printer cable and network cable
connected?
Was the machine powered on before the
printer cable was connected?
Is the print job paused?
Is the USB host blocked?
―
Are the slit glass and the Dual scanning
area dirty?
Corrective Actions
Load the paper correctly.
Load the paper correctly.
Clean the paper separator.
Turn the orientation 180 degrees around
in which the paper is positioned.
Replace the paper with new paper.
Turn the paper over in the cassette, or
turn the orientation 180 degrees around
in which the paper is positioned.
Replace the paper with new paper.
Change the [Correct Paper Curl].
Check the specified cassette and
change its paper type to Custom 8.
NOTE
If you specify the paper type to Custom
8, copy speed or printing speed
becomes slower.
Plug the power cord into an AC outlet.
Turn on the main power switch.
Connect the correct printer cable and
network cable securely.
Power on the machine after connecting
the printer cable.
Resume printing.
Select [Unblock] in the USB host
settings.
Check that the USB memory is securely
plugged into the machine.
Clean the slit glass and the Dual
scanning area.
10-20
Reference
Page
page 3-18
page 3-26
page 3-18
page 3-26
page 10-5
page xiv
page 3-18
page 3-26
page 3-16
page xiv
page 3-18
page 3-26
page 3-16
page 8-59
page 3-30
―
page 2-10
page 2-6
―
page 7-4
page 8-50
―
page 10-3