Care For Interiors; Corrosion Protection - Mahindra XUV 500 Owner's Manual

GENERAL MAINTENANCE

Care for Interiors

Seat Belts
Check to see if dirt has accumulated in
the loops (this usually results in the
s l o w i n g d o w n o f t h e r e t r a c t i o n
mechanism).
Check for cuts and frayed spots in the belt
material. Check to see if the locking and
unlocking mechanism is smooth.
CAUTION
If you encounter any faults, get
them repaired only at an Authorised
Mahindra Dealer. Get the damaged
parts replaced immediately. It is
e s se n t i a l t o r ep l a ce t h e e nt i re
assembly after it has got damaged
in a severe impact even if damage to
the assembly is not obvious.
4-20
Washing the Seat Belts
C a r e s h o u l d b e t a k e n t o a v o i d
c o n ta m i na t i o n of t h e we b b in g w it h
polishes, oils and chemicals. Cleaning
may safely be carried out using mild soap
and water. The belt should be replaced if
webbing becomes frayed, contaminated
or damaged. Use a soft cloth with the
solution to clean the seat belts. Use a
soft-bristle brush with the same solution
for places that are difficult to reach.
CAUTION
Avoid using solvents, such as
bleach, that tend to damage the belt
material.
Windows
Windows need to be cleaned regularly
and completely, both from the inside and
the outside.

Corrosion Protection

Typically, corrosion in vehicles is caused
due to two principal factors:
• Collection of damp-dirt and road salt
on the underside of the vehicle
• Loss of paint and protective coatings
from the exterior and underside of
the vehicle
Corrosion can be prevented through
simple periodic maintenance:
• Repair chips and scratches in the
paint as soon as you find them
• Check the floor
dampness. Carpeting and floor mats
may remain damp for a long time
especially in winter. Dry the areas
immediately.
• Use a high pressure spray to clean
the underside of the vehicle.
V102011© Copyright Mahindra & Mahindra Ltd.
covering for