Accessing Admin Remotely; Setting The Date And Time - Vololink VoloAccess User Manual

VoloAccess™

Accessing Admin Remotely

To access Admin remotely use a Web Browser as follows:
●
Enter the WAN IP Address of the VoloAccess into the address area of a Web Browser and press
Enter. The WAN IP address is obtained from the WAN > 3G Embedded page in Admin under the
heading Network Status.
●
When prompted enter the Admin User ID and Password, then click OK. This is the same User ID
and Password used to access Admin locally.
If your 3G service provider allocates a private IP address to the VoloAccess (this is known to happen
in some cases) then Remote Access to Admin will not work. A private IP address is in one of the
following ranges:
10.0.0.0 - 10.255.255.255
172.16.0.0 - 172.31.255.255
192.168.0.0 - 192.168.255.255

Setting the Date and Time

To set the Date and Time on the VoloAccess follow these steps:
●
From the Navigation panel select System followed by Date/Time - the Date/Time page appears:
The default setting for Time Source is Manual.
●
Enter the current Date and Time.
●
Select your Local Timezone Offset from the drop-down list.
●
Click the Apply button to save the settings.
The Time Source can also be configured to NTP (Network Time Protocol) or NITZ (Network Identity and
Time Zone) meaning the VoloAccess will synchronise the date and time with a time server.
Copyright © Vololink Pty Ltd 2006-2010 V1.43 July 2010
User Manual
Page 50 of 78