Telephone; Telephone Settings; Default Dial - Vololink VoloAccess User Manual

VoloAccess™

Telephone

This section, including Supplementary Services, applies only to Voice Enabled models of the VoloAccess.
To configure operation of the telephone select Telephone from the Navigation panel - the Telephone page
is displayed:

Telephone Settings

The following settings can be configured:
Volume
DTMF Dial Timeout
Country/Region
Line Reversal

Default Dial

Default Dial is a number that can be configured for the VoloAccess to dial automatically after a defined
timeout simply by lifting the handset. This feature can be used as an emergency call facility. To implement
this feature, Enable Default Dial using the drop-down list then click Apply.
●
Enter the Default Dial Timeout (in seconds) and the Default Dial number then click the Apply button.
The valid range for the timeout is between 0 and 10 seconds. The default setting is 5 seconds.
Copyright © Vololink Pty Ltd 2006-2010
This is the handset earpiece volume (1- quiet, 4 – loud).
Define the time from dialling to call setup. This is the time lag between when
you finish keying the number to call, and when the phone starts to dial. The
timeout range is between 2 and 10 seconds. The default setting is 3 seconds.
Select from the drop-down list.
If a Private Automatic Branch eXchange (PABX) is connected to one of the
VoloAccess phone ports, it may be necessary to enable this feature as some
features of a PABX require Line Reversal to clear down the line or help hang
up the call. This feature is required when a PABX is using PSTN as opposed
to ISDN. To enable Line Reversal, select Enabled from the drop-down list.
V1.43 July 2010
User Manual
Page 43 of 78