Signal Strength Indicator; Voice Services (Voice Enabled Models Only) - Vololink VoloAccess User Manual

VoloAccess™
If the WAN State is Connected, you are ready to use your VoloAccess to surf the Internet.
If this is not the case, continue by checking the configuration of the

Signal Strength Indicator

The Admin Status page also displays a graphic readout of the Signal Strength in the top right corner.
Solid blue bars represent signal, outlined bars represent no signal. In the image above, the signal
strength is 3.
Voice Services
(Voice enabled models only)
To use the VoloAccess as a wireless telephone connection:
●
Plug the phone lead into one of the Phone ports on the back of the VoloAccess.
●
Lift the handset (you should hear a dial tone) and dial the number you wish to call. The Phone
Indicator for the selected line
hook.
If Power-on PIN Lock has been
of the normal dial
by lifting the handset and entering #NNNN# (where NNNN is the SIM PIN) then replace the handset.
You can dial international numbers in two ways:
●
dialing <International Prefix><Country Code><Phone Number> or,
●
dialing +<Country Code><Phone Number> using '**' for '+'.
Copyright © Vololink Pty Ltd 2006-2010
on the front of the VoloAccess will flash when the handset is off-
enabled, the dial tone will be different (an intermittent tone instead
tone). On a voice enabled VoloAccess unlock the SIM
APN (Access Point
V1.43 July 2010
User Manual
Name).
using the telephone keypad
Page 15 of 78