System - Vololink VoloAccess User Manual

VoloAccess™

System

The System page displays System Information and allows the configuration System Settings.
From the Navigation panel, select System - the System page appears.
Under the System Information heading the following items appear:
Model Name
System Uptime
Firmware Version
Serial Number
Factory Config ID
Under the System Settings heading the following items appear:
Admin Password
Remote access to Admin
Language
To change the Admin Password:
●
Enter the new password in the editbox, and then click the Apply button.
●
You are prompted to Log in using the new password.
●
Enter the new password and click the OK button.
If Remote Access to Admin is enabled, it is recommended that you change the default password to
prevent unauthorized access.
To enable/disable Remote Access to Admin:
●
Select Enabled or Disabled from the dropdown list. You can also define the port that Remote Access
will use. The default value is port 80.
●
Click the Apply button.
Copyright © Vololink Pty Ltd 2006-2010
This is the Model Name of the VoloAccess.
The lapsed time since the VoloAccess was powered on.
The Version Number of the Firmware installed on the VoloAccess.
The Serial Number of the VoloAccess.
The ID of the factory configuration that the VoloAccess will revert to
when Reset to Factory Defaults.
The default password for the VoloAccess is "password". This should
be changed to protect access to your VoloAccess.
Enable/disable remote access to Admin using the WAN IP Address
(see below).
Select the Language from the drop-down list.
V1.43 July 2010
User Manual
(see below).
Page 49 of 78