Vololink VoloAccess User Manual page 27

VoloAccess™
Enable WAN Ethernet Port
The WAN Ethernet port can be configured manually or, by selecting DHCP to automatically obtain an
IP address from an external WAN modem/router. Selecting DHCP should be suitable for most users.
If Manual is selected, it is necessary to enter the following information:
IP Address
Netmask
Gateway
DNS 1
DNS 2
The above information can be obtained by accessing the configuration page(s) of the external WAN
modem/router. Refer to the modem/router documentation for further information.
●
Configure the WAN Ethernet port to obtain an IP address automatically as follows:
In the navigation panel select WAN Ethernet – the WAN Ethernet page appears.
●
●
Use the drop-down list box to select DHCP.
●
Click the Apply button. The WAN Ethernet port is now enabled and configured.
●
Connect the WAN port of the VoloAccess to a modem using an Ethernet cable.
●
Wait for 10 seconds then click Refresh - the page reloads with DHCP enabled and expands to include
further Network information together with Traffic Statistics as follows:
It may be necessary to repeat the Refresh several times before the updated information appears.
Copyright © Vololink Pty Ltd 2006-2010
IP Address for the VoloAccess to use on the external Ethernet WAN
Netmask of the external Ethernet WAN
IP address of the external Ethernet WAN Gateway
IP address of the external Ethernet WAN Primary DNS server
IP address of the external Ethernet WAN Secondary DNS server
V1.43 July 2010
User Manual
Page 26 of 78