Front Passenger Seat Fold-Flat Feature - If Equipped; Heated Seats - If Equipped - Jeep grand cherokee 2016 Operating Information Manual

Front Passenger Seat Fold-Flat
Feature — If Equipped
To fold the seatback to the flat load-floor posi-
tion, lift the recline lever and push the seatback
forward. To return to the seating position, raise
the seatback and lock it into place.
Fold-Flat Passenger Seat
Heated Seats — If Equipped
On some models, the front and rear seats may
be equipped with heaters located in the seat
cushions and seat backs.
80
WARNING!
• Persons who are unable to feel pain to the
skin because of advanced age, chronic
illness, diabetes, spinal cord injury, medi-
cation, exhaustion or other physical condi-
tion must exercise care when using the
seat heater. It may cause burns even at
low temperatures, especially if used for
long periods of time.
• Do not place anything on the seat or
seatback that insulates against heat, such
as a blanket or cushion. This may cause
the seat heater to overheat. Sitting in a
seat that has been overheated could
cause serious burns due to the increased
surface temperature of the seat.
Front Heated Seats
The front heated seats control buttons are lo-
cated within the climate or controls screen of the
touchscreen.
• Press the heated seat button
the HIGH setting ON.
• Press the heated seat button
time to turn the LOW setting ON.
• Press the heated seat button
to turn the heating elements OFF.
If the HIGH-level setting is selected, the system
will automatically switch to LOW-level after ap-
proximately 60 minutes of continuous opera-
tion. At that time, the display will change from
HIGH to LOW, indicating the change. The LOW-
level setting will turn OFF automatically after
approximately 45 minutes.
NOTE:
The engine must be running for the heated
seats to operate.
This feature can be programmed through the
Uconnect® system. Refer to "Uconnect® Set-
tings" in "Understanding Your Instrument Panel"
for further information.
once to turn
a second
a third time