Starting And Operating; Starting The Engine; Normal Starting; Extreme Cold Weather (Below -20°F Or −29°C) - Jeep CHEROKEE 2023 Owner's Manual

Hide thumbs Also See for CHEROKEE 2023:
Table of Contents

Advertisement

STARTING THE ENGINE

Before starting your vehicle, adjust your seat, adjust both
inside and outside mirrors, and fasten your seat belts.
WARNING!
 When leaving the vehicle, always remove the key fob
from the ignition and lock your vehicle. If equipped
with Keyless Enter 'n Go™, always make sure the
keyless ignition node is in OFF position, remove the
key fob from the vehicle and lock the vehicle.
 Never leave children alone in a vehicle, or with
access to an unlocked vehicle.
 Allowing children to be in a vehicle unattended is
dangerous for a number of reasons. A child or others
could be seriously or fatally injured. Children should
be warned not to touch the parking brake, brake
pedal or the gear selector.
 Do not leave the key fob in or near the vehicle, or in
a location accessible to children, and do not leave
the ignition of a vehicle equipped with Keyless
Enter 'n Go™ in the ACC or ON/RUN position. A child
could operate power windows, other controls, or
move the vehicle.
Start the engine with the gear selector in the NEUTRAL (N)
or PARK (P) position. Apply the brake before shifting to any
driving range.

STARTING AND OPERATING

N
S
ORMAL
TARTING
Press the brake pedal and place the ignition in the START
position and release when the engine starts. If the engine
fails to start within 10 seconds:
1.
Place the ignition in the OFF position.
2.
Wait 10 to 15 seconds.
3.
Repeat the "Normal Starting" procedure.
NOTE:
Only press one pedal at a time while driving the vehicle.
Torque performance of the vehicle could be reduced if
both pedals are pressed at the same time. If pressure is
detected on both pedals simultaneously, a warning
message will display in the instrument cluster
Tip Start Feature
Place the ignition in the START position and release it as
the starter engages. The starter motor will automatically
disengage itself once the engine is running. If the engine
fails to start, the starter will disengage automatically in
10 seconds. If this occurs:
1.
Place the ignition in the OFF position.
2.
Wait 10 to 15 seconds.
3.
Repeat the "Normal Starting" procedure.
E
C
XTREME
OLD
(B
–20°F O
ELOW
To ensure reliable starting at these temperatures, use of
an externally powered electric engine block heater
(available from an authorized dealer) is recommended.
E
P
XTENDED
ARK
NOTE:
Extended Park condition occurs when the vehicle has not
been started or driven for at least 30 days.
1.
Install a battery charger or jumper cables to the
battery to ensure a full battery charge during the
crank cycle.
page 63.
Ú
2.
Place the ignition in the START position and release it
when the engine starts. For Keyless Enter 'n Go™
ignition systems, press and hold the brake pedal
while pushing the ENGINE START/STOP button once.
3.
If the engine fails to start within 10 seconds, place
the ignition in the OFF position, wait 10 to 15 seconds
to allow the starter to cool, then repeat the Extended
Park Starting procedure.
4.
If the engine fails to start after eight attempts, allow
the starter to cool for at least 10 minutes, then repeat
the procedure.
77
W
EATHER
−29°C)
R
S
TARTING
4

Advertisement

Table of Contents
loading

Table of Contents