WORK
Removing headlight mask with headlight
3.1
Refitting the headlight mask with the headlight
3.2
Checking the headlight setting
3.3
A
0 0 A
–
Switch off all electrical equipment.
–
Remove screw
–
Loosen the rubber band
101401-10
–
Pull out the electric plug connector
headlight.
C00124-11
Main work
–
Connect the electric plug connector
C00124-10
–
Position the headlight mask and fix it with the rubber band
Info
Ensure that the retaining lugs engage in the fender.
–
Position the brake line and wiring harness. Put the clamp on, mount and tighten
screw
.
3
101401-11
Subsequent work
–
Check the headlight setting. (
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
Guideline
Distance
B
0 0 B
B
–
Position the vehicle vertically a distance
Guideline
Distance
A
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
and take off clamp.
1
. Push up the headlight mask and swing it forwards.
2
and remove the headlight mask with the
3
.
1
p. 8)
under the first mark.
B
5 cm (2 in)
A
5 m (16 ft)
.
2
away from the wall.
8