Status2 Menu; Source Field; Channel Field; Quality Field - Motorola DSR-6100 Operator's Manual

3

Status2 Menu

Source Field

Channel Field

Quality Field

Status3 Menu

56
This menu does not appear if the Input field (described on page 25) is set to ASI
In or GigE In. Press the  buttons until the STATUS2 menu appears. This
screen displays the source name, channel number, and the signal quality of the
incoming signal.
STATUS2
E
This status-only field displays the source name, which was entered by the
programmer or network operator at the encoder/uplink to identify the source.
Dashes are displayed when no information is available.
This status-only field displays the selected Virtual Channel number (from the
Channel menu). Dashes are displayed when no information is available.
This status-only field displays a number from 1 to 100 so that the quality level of
the signal can be judged. The signal quality is also displayed as a large bar graph in
the Status3 menu. If it is 35 or less, take action at your site to increase the dish size
or improve the Low Noise Block (LNB) to prevent occasional loss of output.
This menu does not appear if the Input field (described on page 25) is set to ASI In
or GigE In. Press the  buttons until the STATUS3 menu appears. This screen
displays the quality level of the signal as a large bar graph that expands to fill the entire
LCD screen. The following example shows the quality at about 75.
STATUS3
E
Source Channel
--- ----
Signal Quality
|||||||||||||||||||||||.......
Quality
---