Input Field; Mode Field - Motorola DSR-6100 Operator's Manual

Input Field

The Input field displays the active input. To select the input:
Press the 4 button until the cursor is at the Input label and press the ENTER button.
Press the  buttons to scroll to the input that is connected. Unless changed, the
DSR-6100 displays Port 1. Press ENTER to confirm the selection and return to the top
line of the menu. If Port 1 through Port 8 is selected, then use the arrow buttons
( 4 ) to specify the other fields (Mode field, Xpndr field, and Lfreq field) as
needed. These three fields are not visible when ASI In or GigE In is selected.
The following screen prompts the user to confirm the selection and exit the field.
If you press any arrow button ( 4 ) at this point, the Caution screen
disappears and the MANUAL TUNE menu reappears without any changes. To set
the port selection, press the ENTER button.

Mode Field

The Mode field allows selection of the frequency plan type for the satellite signal to
which the DSR-6100 is tuned. If the application is a North American C-band
satellite center frequency, select the transponder number in the Xpndr field.
Otherwise, set this field to LFreq and also set the new field (LFreq) as described
below. The L Freq option can be used for current satellite LNB signals, including
C-band and Ku-band.
Press the 4 button until the cursor is on the Mode label. Then press the ENTER
button to move into the field. There are two choices: Xpndr and L Freq. Press the
 buttons to display the desired choice. Then press the ENTER button to
confirm the selection and exit the field.
If Xpndr is selected, choose a transponder in the Xpndr field. The frequency in the
LFreq field is set automatically and cannot be edited.
If L Freq is selected, the Xpndr field no longer appears because the transponder/
frequency relationship is not known. Select a transponder frequency between 950
and 2150 MHz in the LFreq field. This field is not available when Input field is set
to either ASI In or GigE In.
DSR-6100
Default: Port 1
CAUTION: Service will be interrupted
Press E to continue or
Default: Xpndr
to stop
25