3
Xpndr Field
42
The DSR-6100 displays caution messages for the following conditions:
•
A caution message is displayed when changing from an MPEG program
number selection to a Virtual Channel.
CAUTION: Changing to DCII selection mode
Press E to continue or
Press any arrow button ( 4 ) to back out of the field and leave it
unchanged. Otherwise, press the ENTER button to proceed.
•
If a Virtual Channel is selected that is not in the chosen VCT, then a warning
message, "Not in map" is displayed to the right of the Virtual Channel.
CHANNEL
•
Virtual Channels identify satellite and polarity attributes. The RF input ports
are set up with satellite and polarity attributes. For more details, see "Port
Menu" on page 28. The DSR-6100 uses these satellite and polarity attributes to
determine which RF port to use. However, if a Virtual Channel is selected that
does not match the satellite and polarity attributes of either port, then the DSR-
6100 is unable to determine which port to use and the following caution
message is displayed.
CAUTION: Channel dddd not present
Press E to continue or
Press any arrow button ( 4 ) to back out of the field and leave it unchanged.
Otherwise, press the ENTER button to proceed.
Note: The DSR-6100 cannot decode the chosen Virtual Channel until a port is set
up with the applicable satellite and polarity information.
This non-editable field displays the current (Xpndr) transponder name (alpha/
numeric) that is downloaded. If a Virtual Channel is selected that is not in the chosen
VCT, then a warning message, (Not in map) is displayed to the right of the Virtual
Channel. This field serves as a label or identifier for the signal source. For more
details, see "Port Menu" on page 28.
VCT
Channel Xpndr
E
00000
0000
to stop
(Not in map)
to stop