Bicycle Holder In The Luggage Compartment - Skoda Fabia Owner's Manual

70 Seats and Storage
– Fold the surfaces of the seats and seat backrests of the rear seats forward. First the
right then the left backrest.
A
– Push the net partition housing
and take it out of the mounts of the rear seat backrests on the right in the direction
A
of the arrow .
2
Installing
– Position the net partition housing into the mounts of the rear seat backrests.
– Push the luggage net partition housing in the opposite direction of arrow
as the stop.
– Fold the rear seats back into their original position.

Bicycle holder in the luggage compartment*

Install cross member
– Remove the luggage compartment cover  page 66; if necessary we recommend
to remove, the net partition*  page 69.
– Take the head restraints out of the rear seat backrests and fold the rear seats in
order to extend the luggage compartment as desired.
A
– Release the fixtures at the ends of the cross member by fully loosening and
B
slightly pulling up the securing screws
already opened.
 page 69, fig. 67
in the direction of arrow
A
Fig. 68 Install cross member
A
. The fixtures open when they are not
C
– Position the cross member with the fixed (not pulled out) part onto the right (in
direction of travel) lashing eye and then the pull out part
eye.
A
1
A
– Press the fixtures
B
tighten the securing screws
– Check the attachment of the cross member by pulling it.
WARNING
A
as far
1
When transporting the bicycles in the luggage compartment, ensure the safety
of the passengers transported.
Install bicycle carrier
– Position the approved bicycle carrier on the middle of the cross member, after
pulling up the screw
member and screw the screw
A
– Slacken the screw
B
the moveable part of the carrier, depending on bicycle size, into one of the possible
positions, so that it does not come in contact with the boot lid. We recommend to
place the moveable part of the fixture in such a position that the holes are visible
between the screw
A
– Insert the screw
B
on both sides of the cross member until they lock in place and
A
.
C
Fig. 69 Install bicycle carrier
A
push the frame side rail (alu-part) towards the cross
A
A  fig.
into the nut 69.
A
and take it out of the moveable part of the fixture; position
A
and the moveable part.
A
into the desired position and tighten.
A
onto the left lashing
A