Skoda Fabia Owner's Manual page 192

Skoda fabia
Hide thumbs Also See for Fabia:
Table of Contents

Advertisement

Jump-start cables
Only use jump-start cables which have an adequately large cross-section and insu-
lated terminal clamps. Please pay attention to the manufacturer's instructions.
Positive cable - colour coding in the majority of cases red.
Negative cable - colour coding in the majority of cases black.
WARNING
A discharged battery may already freeze at temperatures just below 0°C. In
case of frozen battery carry out no jump-starting - risk of explosion! Also after
thawing of the battery there is a risk of caustic burns due to leaking acid.
Replace the frozen battery.
Please pay attention to the warning instructions relating to working in the
engine compartment  page 166.
Note
There must not be any contact between the two vehicles otherwise current may
flow as soon as the negative terminals are connected.
The discharged battery must be properly connected to the system of the vehicle.
Switch off any installed telephone and also pay attention to the instructions for use
of the telephone in such a situation.
We recommend that you purchase the jump-starting cable in the specialist shops
of the battery manufacturers.
Using the system
Safety
Start engine
It is important to connect the jump-start cables in the correct order.
Connecting positive terminals
– Attach one end
– Attach the other end
Connecting negative terminal and engine block
– Attach one end
– Attach the other end
Starting the engine
– Start the engine of the vehicle providing current and run the engine at idling speed.
– Now start the engine of the vehicle with the discharged battery.
– Interrupt the attempt at starting an engine after 10 seconds if it does not start right
– Disconnect the cables on the engine in exactly the reverse order they were
Driving Tips
General Maintenance
A
to the positive terminal
1
A
.
A
A
to the positive terminal of the battery supplying the power
2
A
.
B
A
to the negative terminal of the battery supplying the power
3
A
to a solid metal part which is connected firmly to the
4
engine block, or to the engine block itself 
away and wait for about 30 seconds before repeating the attempt.
connected up.
Breakdown assistance
Breakdown assistance
Fig. 157 Jump-starting using the
battery from another vehicle: A - flat
vehicle battery, B - battery providing
current
 fig. 157
of the discharged battery
A
B
.
Technical Data
191
.

Advertisement

Table of Contents
loading

Table of Contents