Skoda Fabia Owner's Manual page 63

62 Seats and Storage
– The head restraints can be inserted into the relevant holes of the folded forward
 fig.
seat cushions 54.
– Fold the seat backrests fully fowards.
Move seats into the initial position
– Install the head restraint in the slightly lifted seat backrest.
– Then push the seat backrest back into the upright position until the securing knob
clicks into place - check by pulling on the seat backrest.
A
– Make sure that the red pin is covered
B
– Move the seat cushion into its original position.
WARNING

Ensure that the seat belts are not damaged when operating the seat back-
rests. Under no circumstances must the rear seat belts be jammed by the folded
back seat backrests.

The belts and the belt locks must be in their original position after folding
back the seat cushions and the seat backrests - they must be ready to use.

Pay attention that the seat backrest is correctly interlocked. It is only then
that the three-point seat belt can reliably fulfil its function.

The seat backrests must be securely interlocked in position so that no
objects in the luggage compartment can slide into the passenger compartment
if there is sudden braking - risk of injury!
Note
If the housing of the net partition* is installed, first of all fold th left seat backrest
forward and then the right double seat backrest.
 page 61, fig. 53
on the right.
Inserting head restraints in the seat cushions
– The rear head restraints can be inserted into the relevant holes of the folded
forward seat cushions.
Removing the seat cushion
The luggage compartment can be increased in size by removing the rear seat.
Removing
– Fold the seat cushion forwards completely.
– Press the wire clamps in the direction of the arrow
cushion from its holder.
Fig. 54 Rear seats: Inserting head
restraints in the seat cushions
Fig. 55 Removing seat cushions
 fig. 55
and remove the seat