Digital Clock; Shift Recommendation For Changing Gears - Skoda Fabia Owner's Manual

18 Instruments and warning lights
On vehicles which are equipped with information display*, you can call up this infor-
mation in the menu SETUP  page 23.
The following will be displayed in the information display* for 10 seconds:
Service in ... km or ... days
Resetting Service Interval Display
It is only possible to reset the Service Interval Display, if a service message or at least a
pre-warning is shown on the display of the instrument cluster.
We recommend having this resetting performed by a specialist garage.
The specialist garage:

resets the memory of the display after the appropriate inspection;

makes an entry in the Service schedule;

affix the sticker with the entry of the following service interval to the side of the
dash panel on the driver's side.
Reset the service interval displays by using the reset button
counter.
On vehicles which are equipped with information display*, you can call up this infor-
mation in the menu SETUP  page 23.
Caution
We recommend that you do not reset the Service Interval Display yourself otherwise
this can result in the service interval display being incorrectly set, which may also result
in problems with operation of your vehicle.
Note

Never reset the display between service intervals otherwise this may result in
incorrect readouts.

information is retained in the Service Interval Display also after the battery of the
vehicle is disconnected.

If the instrument cluster is exchanged after a repair, the correct values must be
entered in the counter for the Service Interval Display. This work is carried out by a
specialist garage.

The data displayed is the same after resetting the display with flexible service inter-
vals (QG1) using the reset button as that for a vehicle with fixed service intervals (QG2).
We therefore recommend having the Service Interval Display reset only by an author-
ised Škoda Service Partner who is familiar with the procedure for resetting the display
with a vehicle system tester.

Please refer to the brochure Service schedule for extensive information about the
service intervals.

Digital clock

The time is set with the buttons
Select the display which you wish to change with the button
change with the button
On vehicles which are fitted out with the information display*, it is possible to set the
time in the menu Time  page 24.
A  page 15 on the trip
6
The clock should not be adjusted while driving for safety reasons but only when
the vehicle is stationary!

Shift recommendation for changing gears*

An information for the engaged gear
ment cluster.
A A  page 15, fig.
and
5 6
A
.
6
WARNING
A  fig. 17
A
15.
A
and carry out the
5
Fig. 17 Shift recommendation for
changing gears
is shown in the display of the instru-