Skoda Fabia Owner's Manual page 205

204 Fuses and light bulbs
A
– Connect the plug to the socket
A
– Screw in the screws again and insert the cover. The cover must engage firmly.
Licence plate light
– Open the boot lid and unscrew the light glass
– Take the defective bulb out of the holder and insert a new one.
– Insert the glass cover of the light again and press it down to the stop - ensure that
the sealing rubber is correctly seated.
– Screw on the light glass slightly.
Rear light unit
Fig. 175 Remove the rear light unit / install the rear light unit
A
.
B
Fig. 174 Remove the licence plate light
 fig.
174.
– Open the boot lid.
– Hold tight the rear light unit with one hand and unscrew the plastic nut with the
 fig. 175
other hand - left.
– Grip the rear light unit and remove it carefully with loosening movements at an
angle to the rear. Do not pull the grommet with the cables out of the body.
– Replace the defective light bulb  page 204.
– When re-installing, first insert the rear light unit with the screw
 fig.
of the body 175.
– Carefully press the rear light unit into the body in such a way that the pins
engage into the supports of the body.
– Hold the rear light unit tight with one hand, screw on the nut with the other hand
 fig.
and tighten it 175.
Caution
When removing and installing the rear light unit make sure not to damage the paint-
work of the vehicle and the rear light unit.
Note
For slackening and tightening the plastic nut use a coin.
Changing light bulbs in the rear light unit
A
into the opening
A
A
B
Fig. 176 Rear light unit: Fitting position
of the bulbs