Skoda Fabia Owner's Manual page 108

Connection with an already paired mobile phone
After switching on the ignition, the connection is automatically established for the
10)
already paired mobile phone
was established.
Disconnecting the connection

By withdrawing the ignition key.

By disconnecting the device in the information display.

By disconnecting the device in the mobile phone.
Solving connection problems
If the system announces No paired phone found, check the operating state of the
telephone:

Is the telephone switched on?

Is the PIN code entered?

®
Is Bluetooth active?

Is the visibility of the mobile phone active?

Was the telephone already paired with the hands-free system?
WARNING
In the event of air transport, the Bluetooth
must be switched off by a specialist garage!
Note

Not valid for all mobile phones which enable a communication via Bluetooth
You can ask at an authorised Škoda Service Partner if your telephone is compatible
with the universal telephone preinstallation GSM II.

Please operate your mobile phone exclusively with a suitable adapter in order to
keep a low radiation in the vehicle.

Inserting the mobile phone into the adapter ensures an optimal sending and
receiving power and offers at the same time the advantage of the battery charging.

The range of the Bluetooth
the vehicle interior. The range is dependent on local factors, e.g. obstacles between the
Using the system Safety
. Check on the mobile unit if the automatic connection
®
function of the hands-free system
®
connection to the hands-free system is restricted to
Driving Tips
devices and mutual interferences with other devices. If your mobile phone is e.g. in a
jacket pocket, this can lead to difficulties when establishing the Bluetooth
with the hands-free system or the data transfer.
Inserting the mobile phone with the adapter*
Only one telephone mount* is factory-fitted. An adapter for the telephone can be
purchased from the range of the Škoda original accessories.
Inserting the mobile phone with the adapter
– First of all push the adapter
into the mount. Press the adapter slightly downwards, until it locks securely into
position.
– Insert the mobile phone into the adapter
instructions).
®
Removing the mobile phone with the adapter
.
– Press simultaneouly the side locks of the mount and remove the mobile phone and
 fig.
adapter 105.
Caution
Taking the mobile phone out of the adapter during the call can lead to interruption of
the connection. When taking out the mobile phone, the connection to the factory-
fitted antenna is interrupted, this reduces the quality of the transmitting and receiving
signal. The charging of the mobile phone battery is also interrupted.
General Maintenance
Communication
Fig. 105 Universal preparation for the
phone
A  fig. 105
in the direction of arrow
A
A
(as specified in manufacturer's
A
Breakdown assistance Technical Data
107
®
connection
up to the stop