Bicycle Holder In The Luggage Compartment - Skoda 2011 Praktik Owner's Manual

– Insert the lateral carrier rail at an angle to the fixing wedges and press it up to
the stop.
– Check the attachment of the lateral carrier rail by pulling it.
Divide the luggage compartment with variable loading floor
The luggage compartment can be divided with the variable loading floor.
– Lift up the part with the holder and secure it by sliding it into the grooves
 fig. 65.

Bicycle holder in the luggage compartment

Install cross member
– Remove the rear seats or fold the seats fully forwards, in order to make available
the necessary space in the luggage compartment  page 58.
Using the system Safety
Fig. 65 Dividing the luggage compart-
ment
Fig. 66 Install cross member
Driving Tips General Maintenance
A
– Release the fixtures at the ends of the cross member by slightly pulling up
B
the securing screws A .
C
– Position the cross member with the fixed (not pulled out) part onto the right (in
direction of travel) lashing eye and then the pull out part
eye.
A
– Secure the fixture to both sides and lock the fixing screws
B
A
– Tighten the fixing screws up to the stop.
C
– Check the attachment of the cross member by pulling it.
WARNING
When transporting bicycles in the luggage compartment, ensure the safety of
passengers .
Install bicycle carrier
– Position the approved bicycle carrier on the cross member, after pulling up the
A
screw  fig. 67 push the frame side rail (alu-part) towards the cross member
A
until the socket latches, and screw the screw
A
– Slacken the screw on the moveable part of the bicycle carrier and pull out,
B
then position the moveable part of the carrier, depending on bicycle size, into
one of the possible positions.
– Insert the screw A into the desired position and tighten.
B
Breakdown assistance
Seats and Stowage
A onto the left lashing
A
A
in place.
C
Fig. 67 Install bicycle carrier
A
into the nut.
A
Praktik Technical data
65