Digital Clock - Skoda Fabia 2005 Owner's Manual

16 Instruments and Indicator/Warning Lights
Resetting Service Interval Display
We recommend having this resetting performed by a Škoda Dealer.
Škoda dealer:
•
resets the memory of the display after the appropriate inspection;
•
makes an entry in the Service Schedule;
•
affix the sticker to the side of the dash panel on the driver's side, where
the following service interval is entered.
It is also possible for you to reset the Service Interval Display with the
A ⇒ page 15, fig. 4
reset button
A
Models with fixed service intervals (QG0)
A
Press the reset button
A
and and hold it down.
If the ignition is switched on, one of the service intervals appears in the
display. Holding the reset button
counter to be reset (the display shows "- - -" and then the trip counter
readout).
The readout OIL will appear in the display after resetting the indicator
INSP and releasing the reset button
and OIL) were reached together.
Repress the reset button
this interval.
Vehicles with extended service intervals (QG1 and QG2)
A
Press the reset button
A
and and hold it down.
Switch the ignition on, release the reset button
button to the right. All counters will be reset to 0.
as follows:
⇒ page 15, fig. 4
with the ignition switched off
A
down for 10 seconds will cause the
A
A
when both service intervals (INSP
A
A
and hold it down for 10 seconds to also reset
A
⇒ page 15, fig. 4
with the ignition switched off
A
and and turn the reset
A
Caution
We recommend that you do not reset the Service Interval Display yourself
otherwise this can result in the service interval display being incorrectly
set, which may also result in problems with operation of your vehicle.
Note
•
Never reset the display between service intervals otherwise this may
result in incorrect readouts.
•
information is retained in the Service Interval Display also after the
battery of the vehicle is disconnected.
•
it is necessary to re-code the Service Interval Display if a new instru-
ment cluster is installed during repair work. This work is carried out by a
Škoda dealer.
•
After resetting the display with flexible service intervals (QG1) using
A
the reset button , the data displayed are the same as for a car with fixed
A
service intervals (QG2). We therefore recommend having the Service
Interval Display reset only by a Škoda dealer who is familiar with the
procedure for resetting the display with a vehicle system tester.
•
Please refer to the brochure Service Plan for extensive information
about the service intervals.

Digital clock

A reset button is installed on the left below beside the speedom-
⇒ page 12, fig.
eter for adjusting the clock
Setting clock
– Turn the reset button to the left.
2.