Make An Outgoing Call During Ptt Call; End Or Leave A Ptt Call - AT&T TL86103 User Manual

Multiple handset use
Push-to-talk (PTT)

Make an outgoing call during PTT call

Using a cordless handset or the telephone base:
• During a one-to-one PTT call, press
handset or 1 LINE
PTT call ends automatically.
• During a one-to-group PTT call, press
initiating handset or
ends automatically and you get a dial tone.
• During a one-to-group PTT call, press
one of the destination handsets or
That device gets a dial tone. The PTT call continues for the rest of the PTT
participants.

End or leave a PTT call

Using a cordless handset or the telephone base:
For one-to-one PTT calls, both initiating and destination devices can end the
PTT call. For PTT calls to multiple devices, the initiating device can end the PTT
call. If any one of the destination devices leaves the PTT call, the call continues
until all participants or the initiator hangs up.
Press OFF/
CANCEL
telephone base. The screens show Push to talk Ended.
-OR-
Place the cordless handset in the charger. The handset returns to idle mode.
The telephone base screen shows Push to talk Ended.
NOTE: After PUSH TO TALK on the handset or PTT on the telephone base is released, the PTT
call remains open for a short time. If no one presses PUSH TO TALK on the handset or PTT on
the telephone base within ten seconds, the PTT call ends automatically.
or 2 LINE on the telephone base to get a dial tone. The
1 LINE or 2 LINE
or END on the handset, or press CANCEL or
LINE 1/ or
FLASH
LINE 1/
FLASH
on the telephone base. The PTT call
LINE 1/
FLASH
1 LINE or 2 LINE
85
LINE 2/ on your
FLASH
or LINE 2/
FLASH
or LINE 2/
FLASH
on the telephone base.
END
on the
on any
on the