Wall Mounting - Moxa Technologies EtherDevice Hardware Installation Manual

Wall Mounting

For some applications, you will find it convenient to mount Moxa
EtherDevice Server on the wall, as illustrated below.
STEP 1:Remove the green plastic DIN-Rail attachment plate from Moxa
EtherDevice
Server's rear panel, and then attach the wall mount plates, as
shown in the diagram below. Note that each plate has three
rows of two screw holes—use whichever row of screw holes is
most appropriate for your application. You should also
differentiate between the top plate and bottom plate, as
indicated below. Once the plates are attached, the keyhole
shaped apertures should be such that the large part of the hole
is at the bottom of the keyhole.
2-4
MOXA EtherDevice Server Hardware Installation Guide
⇒