Moxa Technologies EtherDevice Hardware Installation Manual page 23

STEP 2:Mounting Moxa EtherDevice Server on the
wall requires 4 screws. Use the server, with
wall mount plates attached, as a guide to
mark the correct locations of the 4 screws.
The heads of the screws should be less than
6.0 mm in diameter, and the shafts should be
less than 3.5 mm in diameter, as shown in
the figure to the right.
NOTE
Test the screw head and shank size by
inserting the screw into one of the keyhole
shaped apertures of the Wall Mounting
Plates, before it is screwed into the wall.
Do not screw the screws in all the way—leave a
space of about 2 mm to allow room for sliding the wall
mount panel between the wall and the screws.
STEP 3: Once the screws are fixed in the wall, insert the four screw
heads through the large parts of the keyhole shaped apertures,
and then slide Moxa EtherDevice Server downwards, as
indicated below. Tighten the four screws for added stability.
MOXA EtherD
Installing MOXA EtherDevice Server
⇒
evice Server Hardw are Installati on Guide
2-5